Pulse Control V1.2 takes the Waldorf Pulse into previously unknown territory adding three Modulation and three Gate Sequencers, an Advanced Arpeggiator/Sequencer with Scale Remapper, 2 Additional 32 Stage Envelopes, an Advanced programmable LFO, and local/Global Randomization. Using this plugin gives complete control over each of the Oscillators allowing independent Sequencing via the Modulation Sequencers. This allows creating complex one finger style sequences which will make you doubt that the pulse is a mono synth. Pulse Control additionally adds a second software based Modulation Matrix with 7 slots with most of the Pulses parameters available as Destinations.
 
Pulse Control also can be used on a basic level as an interface to the Pulses on-board parameters, all of which are displayed on the main page. For those who have a midi controller set up to control the Pulse, it will also control the plugin and full VST automation is supported. The plugin does not use the Pulses internal patch system, instead patches are store within the plugin/project and restored when reloaded like all other VST Instruments.
New feature:
    * Newly Developed Arp engine installed with Polyphonic Mode for chained Pulses (although it can be interesting with 1 Pulse as well!).
    * Scale Mapper, mainly for use with the Arp, each note can have a distinct scale to squash the sequence into.
    * Clock send now disabled by default, enabled via the send clock button in the master section.
    * Panic will now send on all 16 channels, just in case the plugin has been routed externally to a differing channel to the plugin channel.
    * Cross Modulation Oscillator Mode added to Oscillator 2.